Mitox 331 Owner's Manual

OWNER’S MANUAL PETROL BRUSH CUTTER 261 /331 USER MANUAL, MAINTENANCE INSTRUCTIONS AND SPARE PARTS  READ THIS MANUAL CAREFU

9 USING THE BRUSH CUTTER CHOOSING THE CUTTING DEVICE Choose the most suitable cutting device for the job to be done, according to these general

10 SAFETY AND OPERATION • This brush cutter is equipped with

11 AVOID NOISE PROBLEMS • Check and follow the local regulations for sound levels and hours of operation for garden machinery. • In general, opera

12 FUEL STORAGE • Mixed two-stroke fuel which has been left unused for a period of one month or more may damage the carburettor and

13 • Set the ignition switch Fig 18 to the RUN ( I ) position. Fig 18 Fig 18 • Slowly pull the recoil starter handle until e

14 • During the first ten hours of work, avoid running the engine at maximum speed for a prolonged period until all the components have bedd

15 CARBURETTOR • The carburettor mixture setting has been set at the factory and will not need adjusting. • Adjusting the idle speed Fig 23. I

16 GEAR CASE • Remove the bolt A on the gear case Fig 25, top up the gearbox using Lithium grease and refit the bolt. REPLACING THE NYLON

17 TROUBLESHOOTING Engine will not start, power loss. • Check that the fuel tank is not empty. Fill with mixed fuel. • The fuel does not reach

18 TECHNICAL SPECIFICATIONS Above specifications are subject to change without notice. MODEL MITOX 261 Type Air cooled 2-stroke petrol eng

1 DESCRIPTION U 1 BLADE 3 Point blade for grass, weed or brush cutting applications. 2 DRIVE SHAFT Contains th

19 CONDITIONS OF WARRANTY The manufacturer warrants the product against faulty materials and workmanship for a period of 2 years from the date of f

Brand. Marque. Marca Done at: Name :Fait à : Nom :Fatto a : Nome : Declaraciòn de Conformidad CE -CE declaration of Conformity - MITOXDeclaration

2 TABLE OF CONTENTS DESCRIPTION... 1 SAFETY

3 SAFETY SYMBOLS Warning: Danger, Caution Read the documentation and safety instructions which are provided in this user manual. When operat

4 TAKING CARE OF WARNING LABELS • Always keep warning labels clean and free of scratches, which might make them illegible or difficult to read. If

5 SAFETY PRECAUTIONS INTRODUCTION • Read this Owner/Operator Manual carefully. Be sure you understand how to operate this brush cutter properly bef

6 ASSEMBLY OF THE BRUSH CUTTER The blade fitted to the guard is sharp and can cause injury, always wear gloves INSTALLATION OF THE GUARD • Lay

7 INSTALLATION OF THE 3 TOOTH BLADE Always wear gloves when touching the blade • Lay the brush cutter on its back with the gearbox shaft facin

8 INSTALLATION OF THE U HANDLE • Remove the upper cap from the bracket by undoing the 4 screws. • Install the handle assembly into the seating