Mitox 6220 Owner's Manual download pdf (Page 12)

■ RUNNING IN

• During the first ten hours of work, avoid running the engine at maximum speed for a prolonged period until all

the components have bedded in. After the engine has been run in, it will reach its maximum power.

After two hours of work, check that all nuts bolts and screws are securely fastened and tighten if

necessary.

■ CHECKING THE SAW CHAIN LUBRICATION SUPPLY

• After starting the engine, run the chain saw at medium speed and see if

chain oil is sprayed as shown in the figure.

■ STOPPING ENGINE

• Release the throttle lever and allow the engine to run at idle for half a minute.

• Shift the ignition switch to the STOP position (“0”).

• Except for an emergency, avoid stopping the engine while at full throttle.

■ CARE AND MAINTENANCE OF YOUR CHAIN SAW

• In order to maintain the chain saw in good working order, perform the maintenance and checking operations

described in this manual at regular intervals. In the event that any part needs to be replaced, please contact

the nearest authorised service dealer for assistance.

• Always stop the engine and allow to cool before performing any maintenance or checking procedures.

• When sharpening, removing, or reattaching the saw chain always wear chain saw safety gloves and use only

appropriate tools and equipment to prevent injury.

• When replacing saw chain or any other parts, use only genuine spare parts and approved lubricants.

• Disconnect the spark plug to prevent accidental starting when carrying out routine maintenance.

■

MAINTENANCE AFTER EACH USE

■ AIR FILTER

• To clean dirt in the air filter, split the air filter and wash with warm soapy water. When using

compressed air, blow from the inside.

• To assemble the air filter halves, press until they click together.

■

OILING PORT

• Dismount the guide bar and check the oiling port for clogging and clean as necessary.

■ GUIDE BAR

• When the guide bar is dismounted, remove sawdust from the bar groove and the oiling

port.

Oiling port

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

No comments

Mitox 6220 Owner's Manual Page 12